Faculty of Humanities and Sciences

Permanent URI for this communityhttps://rda.sliit.lk/handle/123456789/4205

Browse

Filters

20212

Advanced Search

Filter by

Settings

Author: search.filters.author.Thambiliyagodage, C. JSubject: search.filters.subject.Photocatalysis

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    PublicationOpen Access
    Photocatalytic activity of Go/Fe3O4 fabricated by Sri Lankan graphite under visible light irradiation
    (Faculty of Science, University of Kelaniya, Sri Lanka, 2021-10) Usgodaarachchi, L; Thambiliyagodage, C. J
    Graphene oxide (GO) was synthesized using Sri Lankan naturally available graphite by modified Hummer’s method. Fe3O4 nanoparticles were synthesized successfully by co-precipitation of Fe3+ and Fe2+ in a 2:1 molar ratio via the addition of NH4OH. Magnetically separable GO/Fe3O4 nanocomposite was fabricated by synthesizing Fe3O4 nanoparticles in the presence of GO. The synthesized nanocomposites were characterized by X-ray diffractometry (XRD), Scanning electron microscopy (SEM), and FT-IR spectroscopy. The formation of GO was confirmed by the C(002) peak at 9.39° in the XRD pattern. XRD pattern of the nanoparticles confirms the formation of crystalline Fe3O4 nanoparticles, and the diffraction peak corresponds to graphene oxide disappear in the GO/ Fe3O4 due to the absence of the folded structure of graphene oxide. SEM image of GO shows the crumpled and wrinkled lamellae structure of graphene oxide, and the images of GO/ Fe3O4 show the distribution of Fe3O4 nanoparticles with an average size of 107 nm on GO where the folded structure of GO was not present while restacking of the nanosheets, was observed. FT-IR spectrum of GO shows the presence of polar oxygenated functional groups such as carboxylic acid (-COOH), hydroxyl (-OH), and epoxy (-COC-). The photocatalytic performance of the photocatalysts was evaluated on photodegradation of methylene blue under visible light irradiation. The GO/ Fe3O4 shows better adsorption behaviour and excellent photocatalytic activity where it could be successfully used for three cycles without significant activity loss. The rate constant for the degradation of MB (0.0187 min-1 ) at the first cycle decreased to 0.0101 min-1 at the third cycle. The conversion of MB decreased from 98.31% at the first cycle to 92.15% at the third cycle. The drop in the conversion is only 6.16% going from cycle 1 to 3, which could be due to the accumulation of the MB molecules at the pore structure. The obtained high photocatalytic activity could be due to the enhanced charge separation resulted due to the presence of GO sheets and better interactions between GO and Fe 3O4.
  • Thumbnail Image
    PublicationOpen Access
    Fabrication of Fe2TiO5/TiO2 binary nanocomposite from natural ilmenite and their photocatalytic activity under solar energy
    (Elsevier, 2021-01-01) Thambiliyagodage, C. J; Mirihana, S; Wijesekera, R; Madusanka, D. S; Kandanapitiye, M; Bakker, M
    Heterogeneous photocatalysis is an attractive alternative route to enhance the degradation of environmental pollutants. In this work, we have fabricated Fe2TiO5/TiO2 binary nanocomposites using natural ilmenite via bottom up approach. Synthesized nanocomposites were characterized by X-ray diffractometry, X-ray fluorescence, transmission electron microscopy, Raman spectroscopy, diffuse reflectance UV–Visible spectroscopy, scanning electron microscopy, and X-ray photoelectron spectroscopy. These nanoparticles are in the range of 40–70 ​nm and are of type I heterostructure with a band gap of 2.02 ​eV. They are sensitive to visible light and show higher photocatalytic activity under direct solar energy. Photocatalytic activity of Fe2TiO5/TiO2 was assessed using a model textile dye, methylene blue. Over a period of 2 ​h, 76% of methylene blue was photodegraded at a rate of 0.0084 min−1 in the presence of Fe2TiO5/TiO2.