Research Papers - Department of Civil Engineering

Permanent URI for this collectionhttps://rda.sliit.lk/handle/123456789/598

Browse

Filters

20252

Advanced Search

Filter by

Settings

Start date: 2025Subject: search.filters.subject.Compressive strength

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    PublicationEmbargo
    Uniaxial compressive response of cement mortar with waste aluminium fibre sourced from electrical distribution cables
    (Springer Science and Business Media, 2025-01) Perera K.D.Y.G.; Ahamed Y.L.F; Somarathna H.M.C.C; Jayasekara D.A.B.P.M; Mohotti D; Raman S.N
    Electrical distribution and communication cables cease to function for transmission when their length is insufficient, and it is considered as it approaches the end of their useful lives. Further, the disposal techniques are not eco-friendly. This study aimed to evaluate the feasibility of cement mortar systems with the inclusion of aluminium fibre extracted from electrical distribution cables. Two diameters of 1.35 mm and 1.70 mm and two lengths of 10 mm and 15 mm fibres were used while incorporating four volume ratios, particularly 0.5%, 1.0%, 1.5%, and 2.0% to evaluate the effect of the length, diameter and volume ratios. The compression test and density test were performed to study the behaviour of Metal Fibre Reinforced Mortar (MFRM) systems under both dry and wet states. Compared to conventional mortar, the ultimate compressive strength of MFRM systems was increased up to 39.4% in 1.5% of fibre addition under the 28-day dry state, where the 1.5% volume ratio showed the best performance under compressive loads. Strain at ultimate strength, modulus of elasticity and strain energy also showed improvements with the fibre inclusion up to 74.4%, 87.3%, and 106.6% respectively. Fibres with higher aspect ratios showed significant effectiveness among the aforementioned fibre variations. The overall results highlighted that the MFRM with 1.5% of fibres performed expertly with 15 mm length and 1.35 mm diameter under compression loads
  • Thumbnail Image
    PublicationEmbargo
    Mechanical and durability analysis of eco-friendly light weight cement blocks using raw rice husk as a partial replacement for manufactured sand
    (Elsevier Ltd, 2025-03-08) Thavarajah, L; Sundaralingam, K; Tharmarajah, G
    The study investigates the mechanical and durability properties of cement blocks made by partially replacing manufactured sand (M-sand) with raw rice husk (RRH). The rising demand for sand in construction, coupled with the environmental impact of its extraction, has prompted the exploration of alternative materials. RRH, a byproduct of rice milling, offers an eco-friendly substitute for sand. The research examines blocks containing varying proportions of RRH (20 %, 40 %, and 60 %) and compares treated and untreated husks. Key parameters, including compressive strength, tensile strength, density, performance when exposed to heat, and water absorption, were analyzed. The results show that up to 40 % of RRH can be used to replace sand without compromising the blocks' structural integrity. Treated RRH blocks demonstrated better bonding with cement, leading to higher compressive and tensile strengths compared to untreated ones. A 40 % RRH replacement achieved an average compressive strength of 3.57 MPa, surpassing the minimum requirements for non-load-bearing masonry units as per Sri Lankan and Australian standards. However, increasing RRH content to 60 % significantly reduced strength and durability. Additionally, RRH blocks exhibited a decrease in density, offering advantages in terms of transportation and handling. Water absorption increased with higher RRH content due to its porous nature yet remained within acceptable limits for treated blocks. These findings suggest that RRH can be a sustainable alternative to sand in masonry applications, especially in rural and eco-conscious construction.