Faculty of Humanities and Sciences

Permanent URI for this communityhttps://rda.sliit.lk/handle/123456789/4205

Browse

Filters

20212

Advanced Search

Filter by

Settings

Author: search.filters.author.Thambiliyagodage, C. JSubject: search.filters.subject.Photodegradation

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    PublicationEmbargo
    One pot synthesis of α-Fe2O3/turbostratic carbon composites and their photocatalytic activity under sunlight
    (Elsevier, 2021-10-01) Thambiliyagodage, C. J; Nakandala, S; Siriwardana, B; Lansakara, B
    Sucrose naturally obtained from sugar cane was catalytically graphitized by incorporation of varying amounts of iron (1, 5, 7.5 and 10%) as a one-pot synthesis. The weight of iron was varied relative to the weight of sucrose. Synthesized sucrose-Fe2O3 nanocomposites (FeGC) were characterized by X-ray diffractometry (XRD), Raman spectroscopy, and UV-Visible spectroscopy. It is observed that turbostratic carbon is produced upon the incorporation of iron and the percentage of graphitization increase with increasing loading of iron as revealed by XRD analysis. Quantitative analysis of Raman spectra confirm that the ordering of carbon increase with increasing loading of iron. The equilibrium adsorption capacity of carbon with the highest iron loading (10FeGC), 0.50 mg/g is higher than that with carbon without any metal, AC (0.2 mg/g), and the highest adsorption capacity (0.58 mg/g) resulted in carbon with 5% iron (5FeGC). Methylene blue adsorption to AC and carbon with 1% iron (1FeGC) followed pseudo-first-order kinetics and carbon materials with 5, 7.5 and 10% iron followed pseudo-second-order kinetics. The initial rate constant for the photodegradation of methylene blue in the presence of AC was 0.001 min−1 and that of 1FeGC (0.005 min−1) increased with increasing loading of iron where the highest initial rate constant (0.158 min−1) was obtained with 10FeGC. Ordered carbon enhances photocatalytic activity by being photoactive and increasing the separation of charges generated at α-Fe2O3.
  • Thumbnail Image
    PublicationEmbargo
    Photocatalytic activity of N, Fe and Cu co-doped TiO2 nanoparticles under sunlight
    (Elsevier, 2021-01-01) Thambiliyagodage, C. J; Usgodaarachchi, L
    Photocatalytic activity of N doped with one transition metal is well known. This article reports the synthesis of TiO2 nanoparticles doped with only N, N co-doped with Fe, N co-doped with Cu and N co-doped with both Fe and Cu by sol-gel method. Their photocatalytic activity was evaluated for the degradation of methylene blue under sunlight. Nanoparticles were characterized by X-ray diffractometry (XRD), Raman spectroscopy, transmission electron microscopy (TEM), scanning electron microscopy (SEM), and diffuse reflectance UV–visible spectroscopy (DRS). XRD analysis revealed the presence of anatase phase TiO2 nanoparticles which was confirmed by Raman spectroscopic and TEM analysis. The crystal structure has not been disturbed by doping with N, Fe and Cu as shown by both XRD and Raman analysis. TEM and SEM images exhibit the nanoparticles which are interconnected due to sintering. XPS analysis revealed the presence of the only Ti4+ in undoped TiO2 but both Ti4+ and Ti3+ are present in doped TiO2 nanoparticles. According to the DRS analysis, the band gap of all doped TiO2 is lower than that of the undoped TiO2, where N, Fe and Cu co-doped TiO2 showed the lowest band gap (2.51 ​eV) proving that the visible light sensitivity of TiO2 increase with metal and non-metal doping. The rate of photodegradation of methylene blue in the presence of undoped TiO2 (0.016 min−1) is higher than all the doped TiO2 nanoparticles. N doped TiO2 show the highest activity among the doped TiO2 nanoparticles (0.006 min−1). Doped TiO2 nanoparticles showed a lower photocatalytic activity due to the electron hole pair recombination and the shielding effect of the dopants.