Research Publications

Now showing 1 - 2 of 2

Open Access
Effective Waste Management Strategies of Bentonite in Sri Lanka
(SLIIT, 2022-02-11) Guruge, K; Coomasaru, P
One of the greatest challenges of Bentonite usage in construction industry is, managing the wastage created in sites thus, it has to be given attention. Therefore, the study would be conducted focusing on the domestic piling construction sites and the process followed by them. Although it is a chemical, it is recognized to be safe for both the environment as well as mankind in an ecological and health protection perspective. However, a proper disposal method in order to reduce the further issues as excessive waste in sites is needed. Therefore, this study aims to explore an effective method regarding the waste management strategies for Bentonite in Sri Lanka. The objectives of the study are, identifying the wasting methods of Bentonite, identifying causes of disposing Bentonite and determining the most suitable method for Bentonite disposal. Data for the objectives one and two were collected through a literature survey and analyzed by using NVivo which was validated using a questionnaire by majority of 5-10 years experienced professionals aligning to mixed method approach. Data for the third objective was found by aegis of the same questionnaire. Noticeably, it was validated through interviews by the industry experts with more than 30 years of experience. The study found that, site conditions are the most relatable reason for the Bentonite waste. Apart from that ‘weather’ and ‘manual handling errors’ can be additional reasons for the wastage. Moreover, most sites consider either ‘when the slurry forms into a cake’ or ‘silos are full’ as the causes for disposal. Furthermore, it has identified that the majority of sites dispose the waste to disposable lands using bowsers as of the disposal method after reusing 3-4 times. The suggested method appears to be cost effective and efficient in comparison to the others. Furthermore, it can be rather safe and environmentally friendly.
Embargo
Suctions, stresses and strengths in unsaturated sand–bentonite
(Elsevier, 2002-05-01) Tang, Gary X; Graham, James; Blatz, James; Gray, Malcolm; Rajapakse, R. K. N. D
This paper presents suction and strength characteristics for a dense, compacted, unsaturated sand–bentonite mixture under a variety of preparation and stressing conditions. Suctions were determined experimentally using thermocouple psychrometers and the filter paper method. They are shown to be related to water contents, saturation, dry densities and osmotic agents. The influence of the initial suctions on strength was evaluated using quick undrained triaxial compression tests, here called ‘constant-mass’ tests. Examination of the suction response to applied external stresses was carried out using stress-controlled triaxial tests along selected stress paths. These tests measured suctions in tests where the mean stress p and deviator stress q were changed systematically to give a series of constant values of Δq/Δp. The results showed that suction decreased as mean stress loading increased. Suction changes appear to be produced only by the mean stress component of the stress tensor and not by the shear stress component. In this compacted sand–bentonite material, for the pressure range at which the tests were performed (p′≤3 MPa), changes in suction produced by changes in mean stress are largely reversible.

Research Publications

Browse

Filters

Advanced Search

Filter by

Settings

Sort By

Results per page

Search Results