Faculty of Computing

Permanent URI for this communityhttps://rda.sliit.lk/handle/123456789/4202

Browse

Filters

2016 - 20173

Advanced Search

Filter by

Settings

Author: search.filters.author.Gamage, ASubject: search.filters.subject.Design

Search Results

Now showing 1 - 3 of 3
  • Thumbnail Image
    PublicationEmbargo
    Design of a kinetic energy harvester for elephant mounted wireless sensor nodes of jumbonet
    (IEEE, 2016-12-04) Wijesundara, M; Tapparello, C; Gamage, A; Gokulan, Y; Gittelson, L; Howard, T; Heinzelman, W
    In areas where the habitats of elephants and humans are rapidly encroaching on each other, real-time monitoring of the elephants' locations has the potential to drastically improve the co-existence of elephants and humans, resulting in reduced deaths in both groups. However, as tagging (using GPS collars) elephants to obtain such location information is difficult and costly, it is important to ensure very long lifetimes of the tags, which can only be achieved using energy harvesting. In this paper, we present a kinetic energy harvester that uses magnetic levitation and ferro fluid bearings to generate energy from an elephant's movements. In order to determine the feasibility of using this kinetic energy harvester for powering the tags on elephants, we obtained real acceleration data collected from an Asian elephant over a 10 day period, and this data was then used to tune the system to maximize the harvested energy. Using experimentally validated analytical and simulation models, and the actual elephant acceleration data, we find that our prototype can generate 88.91J of energy per day. This energy is not only sufficient to power the tags to acquire and transmit locations 24 times a day to a distance of 114Km (line of sight), but provides a surplus of at least 35.40J, which can be used to increase the frequency of position updates or to support alternative communication options such as GPRS. Therefore, this shows the viability of long-term tracking of elephants.
  • Thumbnail Image
    PublicationEmbargo
    Design of a Low-Frequency Linear Motion Testbed for Electromagnetic Kinetic Energy Harvesters in JumboNet
    (IEEE, 2017-09-14) Wijesundara, M; Gamage, A; Gokulan, Y; Tapparello, C
    Kinetic energy harvesting on animals is an emerging technology that could facilitate real-time monitoring of wild elephants. Real-time monitoring is a proven solution to the Human-Elephant Conflict, a problem that has spread across Asia and Africa. However, when designing electromagnetic harvesters, it is essential to accurately model the voltage produced due to electromagnetic effects. In this paper, we present the design, development and the complete simulation of a simple and low-cost linear motion testbed that estimates the generation of an electromagnetic harvester. We integrated the dynamic non-linear flux linkage across the coil with an analytical model that accurately estimated the motion of the moving magnet. The experimental measurements from the testbed were better than 80% in agreement with the simulation results within the frequency range of 1Hz to 2Hz.
  • Thumbnail Image
    PublicationEmbargo
    Design of a kinetic energy harvester for elephant mounted wireless sensor nodes of jumbonet
    (IEEE, 2016-12-04) Wijesundara, M; Tapparello, C; Gamage, A; Gokulan, Y; Gittelson, L; Howard, T; Heinzelman, W
    In areas where the habitats of elephants and humans are rapidly encroaching on each other, real-time monitoring of the elephants' locations has the potential to drastically improve the co-existence of elephants and humans, resulting in reduced deaths in both groups. However, as tagging (using GPS collars) elephants to obtain such location information is difficult and costly, it is important to ensure very long lifetimes of the tags, which can only be achieved using energy harvesting. In this paper, we present a kinetic energy harvester that uses magnetic levitation and ferro fluid bearings to generate energy from an elephant's movements. In order to determine the feasibility of using this kinetic energy harvester for powering the tags on elephants, we obtained real acceleration data collected from an Asian elephant over a 10 day period, and this data was then used to tune the system to maximize the harvested energy. Using experimentally validated analytical and simulation models, and the actual elephant acceleration data, we find that our prototype can generate 88.91J of energy per day. This energy is not only sufficient to power the tags to acquire and transmit locations 24 times a day to a distance of 114Km (line of sight), but provides a surplus of at least 35.40J, which can be used to increase the frequency of position updates or to support alternative communication options such as GPRS. Therefore, this shows the viability of long-term tracking of elephants.