Research Papers - School of Natural Sciences
Permanent URI for this collectionhttps://rda.sliit.lk/handle/123456789/1352
Browse
2 results
Search Results
Publication Open Access The photocatalytic and antibacterial activity of graphene oxide coupled CoOx /MnOx nanocomposites(Elsevier B.V., 2025-02) Liyanaarachchi, H; Thambiliyagodage, C; Jayanetti, M; Ekanayake, G; Wijayawardana, S; Samarakoon, UCoOx and MnOx metal oxide composites were fabricated via co-precipitation varying the Co:Mn (CM) weight ratio as 4:1, 2:1, 1:1, 1:2 and 1:4, and they hydrothermally coupled with 30 wt% of graphene oxide (GO). XRD analysis revealed the presence of Co3O4 and CoO, and Mn2O3 and Mn3O4 phases in pure CoOx and MnOx metal oxides, respectively. The irregularly shaped metal oxide nanocomposites comprised Co3O4, Mn2O3 and Mn3O4 phases and were immobilized on GO. The band gap values of the composites varied in the range of 1.86 – 2.22 eV. The highest photocatalytic activity with a rate constant of 3.5 × 10−3 min−1 was obtained with CMG (1:4). The total removal of MB increased by 55.8 % when CM (1:4) were coupled with GO. The rate of photocatalysis was dramatically increased in the presence of S2O82- and was decreased in the presence of EDTA and isopropyl alcohol. The effect of catalyst dosage was determined by varying the weight to 25, 50, 75, and 100 mg, and the dye concentration was varied in the range of 25, 50, 75 and 100 mg/L. The presence of Pb2+ and Rhodamine B decreased the photocatalytic activity, while it remained the same in the presence of Cl- and PO43- as co-pollutants. The photocatalytic activity of CMG (1:4) was reduced to 72 % upon using the catalyst for five cycles. All the synthesized nanocomposites exhibited greater sensitivity to the Gram-positive strain than the Gram-negative strains.Publication Open Access Efficient photocatalysis of Cu doped TiO2/g-C3N4 for the photodegradation of methylene blue(Elsevier, 2023-03-06) Liyanaarachchi, H; Thambiliyagodage, C; Liyanaarachchi, C; Samarakoon, UThe release of dyes into normal water reservoirs has become a tremendous environmental problem and the development of methods to remove such dyes is essential. A novel photocatalyst was fabricated in which Cu doped to TiO2 was coupled with g-C3N4 (Cu-TiO2/g-C3N4) in different weight percentages as 10, 30 and 50%, hydrothermally. Pure TiO2 consisted of both Anatase and Rutile phases where slight lattice distortions were observed in the Cu-doped TiO2 as evidenced by the XRD and Raman analysis. Cu was present at 1.7% by weight respective to TiO2 according to the XRF analysis. Spherical and irregularly shaped aggregated Cu-doped TiO2 nanoparticles in the range of 15–55 nm were heterogeneously distributed on the g-C3N4 matrix as observed by TEM and SEM. The band gap of TiO2 (3.0 eV) was reduced to 2.67 upon doping with Cu. The band gap of g-C3N4 was found to be 2.81 eV and that of Cu-TiO2/g-C3N4 in different weight percentages were in the range of 2.82 to 2.88 eV. Synthesized photocatalysts were tested on the ability to degrade methylene blue under UV and Visible light. Cu-TiO2/50% g-C3N4 showed the highest rate constant (4.4 × 10-3 min−1) which is 5 and 9.8 times greater than TiO2 and g-C3N4, respectively. The rate constant decreased with the introduction of EDTA and Isopropyl alcohol as they scavenge holes and hydroxyl radicals, respectively. The photocatalytic activity of all the nanomaterials increased with the increasing concentration of persulfate due to the increasing concentration of SO4●- and OH● produced. Synthesized nanomaterials effectively adsorb methylene blue under dark conditions following the pseudo-second-order kinetics suggesting that methylene blue molecules were chemisorbed to the adsorbents. The adsorption rate constant resulting in the best-performing photocatalyst was 0.122 g mg−1 min−1. Hence, it is evident that Cu-TiO2/g-C3N4 can effectively degrade methylene blue.